E
ElektroVodka
As requested by @Kenadian and for anyone else that has the G27 or similar pedals, a small howto.
You can leave everything in the profiler default, so no combined pedals as i might've said on Twitch.
In DCS you go to your axis commands and bind both the clutch and throttle to the corresponding axis (*Rudder).
After that you should have a Joy_Y; Joy_SLIDER2 bound to the rudder like indicated on the screens below.
Now when the axis are bound, hit "Axis Tune" on the bottom of the screen.
Copy the settings from the screens for both axis, and make sure you set the Y axis to be inverted, and slider2 to just "slider" with 50% saturation Y on both axis.
The example is given for the FA-18 but work and should be set for each module separately.
You can leave everything in the profiler default, so no combined pedals as i might've said on Twitch.
In DCS you go to your axis commands and bind both the clutch and throttle to the corresponding axis (*Rudder).
After that you should have a Joy_Y; Joy_SLIDER2 bound to the rudder like indicated on the screens below.
Now when the axis are bound, hit "Axis Tune" on the bottom of the screen.
Copy the settings from the screens for both axis, and make sure you set the Y axis to be inverted, and slider2 to just "slider" with 50% saturation Y on both axis.
The example is given for the FA-18 but work and should be set for each module separately.
